Product Information

Specification

Conductor

Okonite's single conductor PILC cables are available with four different style conductors depending on the application. The four conductor styles are concentric, compressed concentric, compact round and compact segmental

Insulation

Okonite's impregnated paper insulation consists of the finest electrical grade paper made from the highest quality sulfate processed coniferous wood pulp and the purest grade polybutene dielectric fluid. The paper is manufactured to an Okonite Technical Requirement to assure the electrical properties of low dielectric loss and high dielectric strength; as well as mechanical and physical properties to resist tearing and wrinkling during manufacture and subsequent handling during installation. To maintain a smooth, wrinkle-free precisely gapped tape insulation, Okonite carefully slits its own tape pads into widths tailored for each conductor size and wall thickness. Most important, Okonite uses taping machines with the most precise tape tension controls available today.
The impregnating fluid used is of the medium viscosity polybutene type, also manufactured to an Okonite Technical Requirement. Polybutene dielectric fluids are better than natural petroleum based insulating fluids because they resist aging, have lower and more stable power factor values and possess an inherent tackiness which resists draining of the paper tapes. Okonite's impregnating facilities clay filter and degas the dielectric fluid to provide low power factors and stable ionization levels over a wide range of voltage stresses.

Sheath & Jacket

Okonite's copper bearing lead sheath provides an impervious barrier from the environment; in addition, it provides mechanical protection for the insulation and encapsulates the impregnant. All lead sheaths have the inherent capacity for substantial electrical conductivity under short circuit conditions without requiring a separate ground. Okonite's lead sheaths are applied with a continuous lead extruder under the control of a thickness gauge for uniform wall thickness and concentricity.
The Okolene ® jacket provides mechanical and corrosion protection for the lead sheath and is used in most installations. (Indoor and aerial installations may not require a jacket.)
Okolene is a thermoplastic polyethylene material that resists most chemicals and moisture; it is unaffected by oils below 60°C and has a low coefficient of friction which reduces tensions when pulling through ducts and conduits

Specifications

Okonite PILC cables are manufactured in accordance with and meet the requirements of AEIC CS1-90, 11th edition.

Product Features

• Polybutene impregnating fluid.
• 90°C continuous operating temperature.
• 110°C emergency rating.
• 200°C short circuit rating.
• High impulse strength.
• Proven service life of over 40 years.
• Impervious protection from the environment.
• Also available with LS/ZH - Okoclear TP (TPPO), Okoseal (PVC) and ROC (Reinforced Okonite Covering).

*Data provided on this page is subject to change based on different manufacturers' variances

** Images are for display purposes only refer to Product Technical Details for accurate information on the product.