Price (Per FT.)
Okonite Loxarmor Type SP-OS (Pair - Individual and Overall Shield) thermocouple extension cables are designed for use as instrumentation and process control cables in ITC non-classified or labeled circuits up to 150 volts and 5 amps (750VA) and in Class 2 or 3 Power-Limited circuits where maximum shielding against external interference is required, as well as shielding among groups, particularly where the cable may be subject to abnormally high current or voltage interference; indoors or outdoors; in wet or dry locations with a conductor operating temperatures up to 105°C; in cable trays; in raceways; supported by a messenger wire; under raised floors; for direct burial. Suitable Class I, Division 2, Class II, Division 2, or Class III, Division 2 hazardous locations. Also for use as Power-Limited fire protective signaling cable (FPL) per NEC Code 760. The Loxarmor (interlocked steel) sheath provides the physical protection against mechanical damage as required in NEC Section 727-4. It may be installed in both exposed and concealed work, secured to supports not greater than 6 feet apart.
Loxarmor Type SP-OS, Type ITC/PLTC Armored Thermocouple Extension Cable, Multiple Shielded Pairs - 105 Deg. C
This is an instrumentation cable with a capacity to be installed in both exposed and concealed electrical works. It has robust mechanical support that enables it to withstand any damaging agents. The cable is armored and multi-shielded. PLTC Armored Thermocouple Extension cable is good for your control and instrumentation units, the cable has unique properties.
OkoniteLaxarmor Type SP-OS cable is constructed using copper conductor. The conductors are designed in pairs which are each shielded. Copper is highly recommended for its efficient electric signal transmission. It is also strong and reliable.
Type ITC Thermocouple Extension cable is heavily secured with a strong insulation system. This insulation has a high temperature rating of 1050C therefore can endure high temperatures without getting tampered. It is retardant to flames, resists water, chemicals andozone.
Besides, the conductors also have interlocked steel sheath which provides physical security against mechanical damages. This sheath is required by NEC Section 727-4 to be used in the design for this instrumentation cable.
Laxarmor Type SP-OS cable is designed for use as instrumentation and control cables. They apply in the ITC non-classified or labeled circuits whose voltage consumption is up to 150 Volts and 5 amps. It is also applied in class ii and iii Power-Limited circuits where heavy shielding of data is needed. Use this cable in both outdoors and indoors applications, in wet or dry locations and you find no challenges. It can be installed in cable trays, raceways while a messenger wire offers it support.